| Audience | Fleet Admins, Fleet Managers, Drivers |
| Applies To | Asset Gateway Mini |
Answer
If you’ve uninstalled your Asset Gateway Mini, and you’re not planning on re-installing it immediately, you should put the Asset Gateway Mini back into “ship mode” to preserve the battery until it is used the next time. You need to hold and release the reset button for 5 seconds (up to 7 seconds). The LED will blink red for 3 seconds and the device will go back into ship mode.
When the device is needed again, press and release the reset button with the included pin to activate the device.
Related Content
Was this article helpful?
9 out of 11 found this helpful