| Audience | Drivers, Fleet Admins |
| Applies To | AI Dashcams |
Steps:
1) Make sure the engine is ON and Disconnect the camera
2) Disconnect the ELD
3) Keep the engine ON and Wait for 3 minutes
4) After 3 min turn OFF the engine first and then connect the ELD only,
5) Switch ON the engine and wait for 3 minutes
6) Keep the engine ON and connect the camera to the ELD.
7) Reset the camera on factory settings by pressing the pinhole on the left-hand side of the camera for 25 seconds, Keep it pressed until you see a change in the color of the light
Was this article helpful?
9 out of 11 found this helpful