Motive provides cables for a successful Vehicle Gateway installation. Please follow the steps mentioned below to install the cable 3022 for the Vehicle Gateway.
Installation Requirements: Cable 3022
What comes in the box?
- Cable 3022
Tools
- Adjustable wrench / Philips screwdriver
Steps: Installing Cable 3022
Note: Before starting the installation process make sure that:
|
1. Locate the 6-Pin port in your vehicle. It’s usually located on the Driver’s side underneath the dash panel and is gray in color.
| Note: The numbers in the above image indicate the most probable locations of the diagnostic port. |
a. Fleets can request a Y-cable for specific vehicles. Motive recommends only using 1 Y-cable per vehicle when necessary.
2. Connect the 6-pin end of the Motive cable to the vehicle’s 6-pin port.
3. Use the provided zip ties to secure the cables.
4. Attach the 15-pin connector to the Vehicle Gateway.
5. Secure the 15-pin connector to the Vehicle Gateway using the thumbscrews.
6. Use the provided alcohol swabs to clean the mounting area.
7. Remove the adhesive strip’s cover on the back of the Vehicle Gateway and attach it to the mounting area.
8. Once plugged in, the LED lights flash before turning solid red. After approximately 1 minute, the left-side LED light turns green indicating a successful GPS connection.
| Note: The GPS performance may be affected if the Vehicle Gateway is not placed facing out of the vehicle, towards the sky. |
| WARNING: For vehicles that may operate in the State of California, regulations may prohibit the installation of any Y-cable configuration if it involves relocating the in-vehicle diagnostic port. If the vehicle may be operated in California, ensure the installation does not relocate the diagnostic port. Motive customers are solely responsible for their compliance with all applicable laws and regulations |
Share this with others