At the start of every shift, you must pair your Driver App to the Vehicle Gateway installed in your vehicle so driving time can be automatically recorded.
Pairing modes
- Depending on your vehicle’s configuration, the Driver App connects to the Vehicle Gateway through Cellular Relay or Bluetooth. For both pairing modes, Bluetooth must remain enabled because the Driver App uses it to detect nearby vehicles.
- When Cellular Relay is enabled, the Driver App connects to the Vehicle Gateway through the internet or cellular data, while the Vehicle Gateway uses its built-in cellular modem. Cellular Relay does not automatically fall back to Bluetooth if the relay connection is unavailable.
Before you begin
Make sure:
- The vehicle has a Vehicle Gateway installed and assigned to it. If you are not sure, ask your fleet manager.
- Bluetooth is enabled on your phone.
- The Motive Driver App has permission to use Bluetooth.
- Your phone has an active internet connection or cellular data.
- The vehicle ignition is on, and the Vehicle Gateway lights are active.
- You are inside or near the vehicle so the Driver App can detect it.
- If the vehicle uses Cellular Relay, the Driver App is version 107 or later, the vehicle uses a supported Vehicle Gateway (VG3), and the Vehicle Gateway firmware is version 109 or later. Ask your fleet manager or Motive Support to confirm these requirements.
Connect to your vehicle
-
Open the Motive Driver App and swipe up from the bottom of the screen.
-
Tap Connect to a vehicle.
- Grant Bluetooth permissions, if prompted. This only happens the first time.
-
From the Nearby Vehicles list, tap your vehicle.
How to know it worked: The status changes from Connecting to Connected, and the right-side LED on the Vehicle Gateway turns solid green.
| Note: Bluetooth is used to detect nearby vehicles, including vehicles configured for Cellular Relay. It does not necessarily indicate that Bluetooth is being used for the ongoing vehicle connection. |
Troubleshoot common pairing issues
- If the vehicle does not appear in the list, your driver or vehicle may not be configured for ELD-regulated operation. Contact your fleet administrator to have this enabled in the Fleet Dashboard. For more details, see the troubleshooting vehicle selection failure.
-
If your phone shows a Bluetooth PIN prompt, tap Cancel and do not pair the Vehicle Gateway from your phone’s Bluetooth settings. If an existing device named MOTIVE_ followed by a number is saved in your phone’s Bluetooth settings, tap Forget for that device. Then return to the Motive Driver App and select the vehicle there.
Note: The Driver App uses Bluetooth to detect nearby vehicles. When Cellular Relay is enabled, the ongoing vehicle connection uses the relay connection instead. - If the vehicle appears, but the connection fails for a vehicle that uses Cellular Relay:
- Confirm that your phone has an active internet connection or cellular data.
- Confirm that Bluetooth is enabled so the Driver App can detect the vehicle.
- Confirm that the Vehicle Gateway is powered on and assigned to the vehicle.
- Confirm that the Driver App, VG model, and firmware meet the Cellular Relay requirements.
- Remember that Cellular Relay does not automatically fall back to Bluetooth.
- If the Driver App shows Reboot Vehicle Gateway, follow the prompts in the app. If the issue continues, contact Motive Support.
- If Cellular Relay was recently enabled while you were driving, turn off the engine and log out of the Motive Driver App and log back in. Then, select the vehicle again and continue pairing.
- If the Cellular Relay temporarily disconnects, follow these troubleshooting steps.
Confirm you are properly connected
-
Open Logs in the Driver App.
- The screen must show Current Vehicle instead of No Vehicle.
Disconnect at the end of your shift
- Tap Current Vehicle in the Driver App.
-
Tap Leave current vehicle.
How to know it worked: The Logs screen returns to showing No Vehicle.
Why this matters
If the Driver App is not connected to the Vehicle Gateway, driving time may appear as Unidentified or Unassigned Driving and may need to be claimed later. If the Vehicle Gateway is not recording, a trip may not be available to claim.
Share this with others