The Driver ID Reader is a RFID/NFC device that identifies a driver in a vehicle. It needs to be wired to the Vehicle Gateway and mounted within reach of the driver's seat before drivers can tap in.
| Note: Avoid disassembling the device. Don’t use the device on airplanes or near medical equipment. |
Before you begin
- Install a Vehicle Gateway and assign it to the vehicle from the Fleet Dashboard first. The Driver ID Reader connects through the Vehicle Gateway and will not work on its own.
- If no Vehicle Gateway is assigned, assign one before assigning the Driver ID Reader.
- You will need Cable 5005 (sold separately) to connect the Driver ID Reader to your Vehicle Gateway's existing diagnostic cable.
- Choose the recommended switched ignition power source rather than constant power, so the reader only draws power when the vehicle is on.
- Have the following tools that came in the box ready:
- Motive Driver ID Reader
- 10 Cable Clips
- 5 Zip Ties
- 2 RFID Cards
- 4 Adhesives
- Have the following tools available for power wiring:
- Multi-Meter
- Heat gun
- Wire Crimper
- Wire Stripper
- Drill and bits
Choosing a mounting location
When choosing a mounting location for the Driver ID Reader, keep the following points in mind:
- The reader needs to be within reach for drivers to swipe their cards.
- Consider the cable routing between the reader and the Vehicle Gateway when choosing the location.
- Avoid areas with high temperatures, humidity, or direct sunlight to prevent damage.
Installing the Driver ID Reader
- Unplug the existing diagnostic cable (if any) from the Vehicle Gateway's DB15 port.
- Connect the Cable 5005 to the Vehicle Gateway, and the vehicle connector cable to the DB15 connector on Cable 5005.
- Connect the Driver ID Reader's communication socket to Cable 5005's RS232 serial interface. The reader communicates with the Vehicle Gateway via this serial connection.
- If the reader cannot be powered through the serial connection and requires a 12/24v Power source:
- Connect the red lead from the Driver ID harness to the vehicle's 12/24v switched ignition power source.
- Connect the black lead to ground.
- As Driver ID Reader is powered on, the red LED on the device illuminates.
- Once the RFID Reader is powered on, bring the card to swipe with the reader. A successful read of an RFID card causes the green LED to blink once, accompanied by a single beep.
- Peel off the adhesive backing on the Driver ID Reader to mount it in the desired location.
- Use cable clips and zip ties to ensure proper cable routing between the Vehicle Gateway and Driver ID Reader.
Next steps
- Fleet admins can turn audible Driver ID Reader reminders on or off in fleet view admin settings within the Fleet Dashboard. When enabled, the Driver ID reader beeps once every minute until a known Driver ID card is scanned.
Was this article helpful?
Share this with others