The AI Dashcam needs to be mounted and connected to your Vehicle Gateway before it can start recording and detecting unsafe driving, so install it right after your Vehicle Gateway is set up.
Before you begin
- Install your Vehicle Gateway first. The AI Dashcam draws power and connectivity through it. See Vehicle Gateway Installation.
- Unbox the AI Dashcam and confirm you have the following: camera, USB cable, mounting bracket, wire clips, and an Allen key.
- Clean the section of windshield where you will mount the camera with glass cleaner and a lint-free cloth.
Choose a mounting location
- Pick a spot behind the rearview mirror, within the area the windshield wipers sweep.
- Make sure the camera is not blocking the driver's view of the road.
- For dual-facing models, check that the driver-facing lens has a clear view of the driver's seat.
Connect and adjust the camera
- Plug the USB cable into the AI Dashcam and connect the other end to your Vehicle Gateway's USB port.
- Wait for the AI Dashcam's light to illuminate.
- Adjust the camera angle by hand, or use the Allen key for finer control, so the road and the driver (for dual-facing models) are clearly visible.
How to know it worked: The light bar shows white while booting, then turns solid blue once the camera is active and recording.
If it doesn't:
- Light bar stays off: Check that the USB cable is fully seated in both the AI Dashcam and the Vehicle Gateway and that the Vehicle Gateway itself is powered (its left LED should be green).
- Blinking purple: The camera is disconnected or overheating. Reseat the cable and give it a minute to cool if it has been in direct sun.
Preview the feed before mounting
- Log in to the Motive Fleet App, go to More > Devices > Vehicle Gateway > Dashcam.
- Preview the camera feed and fine-tune the angle if the road or driver view looks off.
Mount the AI Dashcam
- Peel the adhesive backing off the mounting bracket.
- Press it firmly onto the cleaned section of the windshield and hold for at least 30 seconds.
- Use the wire clips to route the USB cable neatly along the windshield edge and dashboard, tucking away any slack.
How to know it worked: The camera stays firmly in place with no visible cable slack, and the light bar remains solid blue.
Verify the installation
- Open the Motive Fleet App and go to Devices, then select your Vehicle Gateway.
- Search for the Vehicle Gateway's serial number and select it.
- Scroll to the Dashcam section and tap the arrow to view the captured images.
How to know it worked: The images show a clear, unobstructed view of the road (and driver, if applicable). Tap Refresh to pull updated images after adjusting the angle.
If the images look wrong: Loosen the mount, re-angle the camera, and check the feed again before it fully sets. Repositioning after the adhesive cures can damage the windshield or mount.
Next steps
- Pair a driver's mobile device to your Vehicle Gateway so trips and safety events are attributed to the right driver.
Share this with others