Environmental Sensor needs to be paired with an Asset Gateway before it can start reporting temperature and humidity. Each Asset Gateway supports up to 6 sensors for independent zone-level readings in single- or multi-zone reefers, so mount it and pair it right after your Asset Gateway is installed. Here's how.
Before you begin
- Make sure you have an Asset Gateway installed for Environmental Sensors and Environmental Sensor assigned to the Asset Profile on the Motive Dashboard.
- Have the following tools available that came in the box ready:
- Mounting Plate
- Reset Pin
- Alcohol Wipe
- Small Mounting Plate Screws
- Large Mounting Plate Screws
- Device Screws
- Spare Adhesive
- Have the following tools available for use:
- T6 Torx Screwdriver
- Ladder
Activating and pairing the sensor
- Use the alcohol wipes included in the box to wipe the area where you want to mount the Environmental Sensor.
- Remove the adhesive backing from the mounting plate and attach it to the area once it has been thoroughly wiped.
- If you are attaching the mounting plate to a metal surface, use the small mounting plate screws. In the case of wooden surfaces, use large mounting plate screws.
- Attach the Environmental Sensor to the plate and secure it in place using the T6 device screws.
- Using the Reset Pin, press the pinhole reset button on the side of the Environmental Sensor to start the pairing process.
- Once the LED starts blinking blue, it means the sensor is starting to connect to the Asset Gateway. Wait for 10 minutes for the pairing process to be successful.
Assigning the Environmental Sensor to an Asset Gateway or Vehicle Gateway
- Log in to the Motive Fleet App and go to More > Devices.
- Tap Install Door and Env. Sensors.
- Select the Environmental Sensor you want to assign from the given list or use the search bar to find the sensor by entering its serial number.
- Tap Continue.
- Select an asset from the given list or use the search bar to find the asset.
- Select the data transmission source between the Asset Gateway or Vehicle Gateway.
-
Select the temperature Zone for the installation of your Environmental Sensor.
-
Select one of the given Location options for the installation.
-
Tap Assign.
-
Confirmation pop-up changes to Assigning… state while the sensor is being assigned.
-
Place the Environmental Sensor at the mounting location and tap Next.
- Follow the given instructions to activate the sensor. Tap Light flashed blue once the sensor is activated and flashing blue.
- Do not press and hold the pinhole button. Instead, quickly press and release it to begin pairing with the Asset Gateway. The LED will start blinking blue if done correctly. If the light does not flash blue, tap Light did not flash blue and follow the given steps for troubleshooting. Sensor data will start refreshing.
- Once refreshed, you can see the Temperature and Humidity of the selected Zone.
- Tap Refresh data if you want to refresh the values again.
- Tap Continue to proceed.
- From Assignment complete screen, you can go to the Installation guide for next steps, tap Install another sensor or tap Finish to proceed as you wish.
- Once the Environmental Sensor and Asset Gateway are paired, the temperature and humidity will appear on your Fleet Dashboard.
How to know it worked: The LED starts blinking blue, showing it's connecting to the Asset Gateway. Give it up to 10 minutes to finish pairing. It will turn solid blue once successful.
If it doesn't:
- LED flashed solid blue: If the LED on the sensor has flashed solid blue, it indicates that the Environmental Sensor has connected to the Asset Gateway.
- Blinking red: Paired Asset Gateway cannot be found. This can happen when the AG mini is on battery power. Ensure the paired Asset Gateway is close to the Environmental Sensor. Press and hold the pinhole button for 8 seconds, then release. Press the button on the Environmental Sensor to restart the device.
- Blinking yellow: Connectivity is weak but working. Consider repositioning the Environmental Sensor closer to the Asset Gateway.
Next steps
- Confirm Environmental Sensor data is populating in the Fleet Dashboard. See Verifying Environmental Sensor installation in the Fleet Dashboard.
Share this with others