The AI Omnicam is Motive's side and rear camera. Paired with your AI Dashcam or AI Dashcam Plus, it gives you 360-degree visibility around the vehicle, catching sideswipes, backing incidents, and cargo issues that a forward-facing camera would miss. AI Omnicam needs to be assigned to a vehicle and mounted before it can start covering your blind spots, so install it using the Motive Fleet App.
Before you begin
- Install a Vehicle Gateway with an AI Dashcam or AI Dashcam Plus on the vehicle first. Fleets cannot assign an AI Omnicam to a vehicle without a Vehicle Gateway and Dashcam already installed.
- Decide your mount:
- Magnetic mount works for quick, temporary installs on any flat metal surface
- Mirror mount is a drill-free option built specifically for Freightliner Cascadia (2018+).
- Ensure having a 5A fuse and a fuse tap or add-a-circuit ready for the power connection.
Assign the AI Omnicam to a vehicle
- Log in to the Fleet App and tap More > Devices.
- Tap Install device.
- Select AI Omnicam.
- Scan the QR code on the back of the device (or the barcode on the box), or tap Select from list.
- Tap Continue once the serial number is identified.
- Select the vehicle and the side you're installing on (Left, Right, or Rear) > tap Confirm.
- Tap Continue.
The app confirms the AI Omnicam is assigned to the selected vehicle side and proceeds to location testing.
Test the installation location before mounting
- Choose a flat spot at the cowl, door, rear, or cargo area with a clear, unobstructed view.
- Tap Test the install location.
- Connect temporary power using the red (12V/24V) and black (ground) wires with a 5A fuse. Never use the blue wrapped wires for a direct connection.
- Wait for the LED to go from blinking white to solid white, then tap Next.
- Tap Connect to AI Omnicam and join its local Wi-Fi when prompted.
- Review the live camera feed and adjust the camera's position until the view is clear, then tap Next.
The live feed displays the coverage area fleets require with an unobstructed field of view.
| Note: Reposition the camera and retest before moving to permanent installation because repositioning after mounting gets difficult. |
Mount the AI Omnicam permanently
- Disconnect temporary power, then tap Get started.
- Attach the metal plate and route the cable through the base plate and grommet hole.
- Connect permanent power (red/black wires, 5A fuse) and wait for the LED to turn solid white.
- Assemble the body mount, making sure the LED faces up toward the sky, and tighten the screws > tap Next.
- A Software Update is performed. Once done, the LED lights turn solid white > tap Next.
| Note: The LED turns solid white after any pending software update finishes, showing the camera is recording. Turn the engine on to confirm you can see the live stream. |
- Recheck the field of view, fleets can still rotate the camera within the mount before final tightening. Once done, analyze the LED state > tap Got it.
|
Note:
|
- Remove the plastic protective film from the camera lens and tap Finish on the Fleet App.
Next Steps
- Repeat these steps to install an AI Omnicam on another side of the same vehicle, or move on to pairing a driver's mobile device. Follow the steps mentioned in Connect a mobile device to the Vehicle Gateway in the Motive Driver App.
Was this article helpful?
Share this with others